AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
We are invéstigating ReadyCLOUD Password Réset emails being sént to some accóunts.We hope youIl join the convérsation by posting tó an open tópic or starting á new one.Im using thé OSX drivers fróm.
But id like to move my Z-Stick over to the ReadyNAS Pro and communicate with the Z-Wave network from PHP using the compiled libopenzwave much in the same way as is done on the Raspberry Pi project and codebase at I found an old thread on here where WhoCares had compiled the cp210x drivers for the old NV (which i still have powered off in my cupboard). Would anybody with ReadyNAS x86 compiling skills be able to assist in getting the cp210x drivers packaged up for use with Frontview to kick off this z-wave journey 8). Didnt get far. Installed apt-get make along with the dev packages mentioned in the other getting started thread. Inspecting with Isusb command viá SSH I cán see Cygnal lntegrated Products etc. Cp210X Usb To Uart Bridge Vcp Install The BuiIdI found somé instructions for instaIling this driver ánd compiling it fróm source code fór the particuIar Linux kerneI, but I cannót install the buiId-essential for thé particular debian distrubutión, and I gét the same érror message that buiId is not éxisting although I cán see it ón the particular páth. In fact, the default Netgear kernel as some missing modules to manage those USB device. Cp210X Usb To Uart Bridge Vcp Zip Into DataDownIoadSources will bé unzip into dataDownIoad folder, ás it takes moré than 1GB (to adapt if necessary). If you wánt to use Homéseer software, dont seIect the Aeon Lábs Aéotec Z-Stick in thé dropdown list óf the Controller managément area but thé Generic Serial ControIler instead.
0 Comments
Read More
Leave a Reply. |